Typical Example 4P4454 Crankshaft Pulley Group (1) Bolt. Tighten bolts to a torque of … 200 ± 25 N·m (150 ± 18 lb ft) 4W5429…
Author: sam
(1) Gear. For installation heat gear (do not use a torch) to … 316°C (600°F) (2) End play for crankshaft assembled in engine … 0.07…
Rear Crankshaft Seal Groups: “A”- Single Lip, “Dry” Applications “B”- Double Lip, “Wet” Applications Front Crankshaft Seal Refer to Disassembly And Assembly for the complete…
Removal Procedure Start By: Remove the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”. Remove bolts (1) . Remove rear…
Removal Procedure Start By: A.Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”. Note: Note the oil hole orientation in each camshaft bearing…
Removal Procedure Start By: A.Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”. 1.Wrap the camshaft with a protective covering in order to…
Installation Procedure 1.Lubricate the camshaft and the camshaft bearings with clean engine oil. 2.Carefully install camshaft (4) and camshaft gear (1) in the engine. 3.Ensure…
Removal Procedure Start By: A.Remove the rocker arms and the pushrods. Refer to Disassembly and Assembly, “Rocker Shaft and Pushrod – Remove”. B.Remove the unit…
(1) Gear. Heat to install (do not use torch). Do not heat above … 316°C (600°F) (2) Distance between shoulder of camshaft and gear for…
Installation Procedure 1.Position water pump belt tightener (3) and install V-belt (2) on the pulley of water pump belt tightener (3) . 2.Install bolts (1)…