Removal Procedure Start By: A.Remove the front gear group. Refer to Disassembly and Assembly, “Gear Group (Front) – Remove”. Note: For information on reusability of…

Installation Procedure Note: The number six main bearing is the thrust bearing. 1.Clean the bearing surfaces in the cylinder block for the main bearings. Apply…

Removal Procedure Start By: A.Remove the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”. B.Remove the engine oil pump. Refer…

Installation Procedure Note: Place clean engine oil on the crankshaft main bearings prior to assembly. Ensure that the tabs on the back side of the…

Removal Procedure Start By: A.Remove the engine oil pump. Refer to Disassembly and Assembly, “Engine Oil Pump – Remove”. 1.Remove bolts (1). Remove crankshaft main…

Installation Procedure 1.Use Tooling (C) to install crankshaft front seal (1) . Note: The crankshaft seal is designed to be installed dry. End By: Install…

Removal Procedure Start By: A.Remove the vibration damper and the pulley. Refer to Disassembly and Assembly, “Vibration Damper and Pulley – Remove and Install”. 1.Use…

Installation Procedure Table 1 Required Tools     Tool     Part Number     Part Description     Qty     C (1)    …

Removal Procedure Start By: A.Remove the crankshaft rear seal. Refer to Disassembly and Assembly, “Crankshaft Rear Seal – Remove”. Note: Wear sleeves are not installed…