3116 and 3126 Truck Engines Crankshaft Rear Seal Carrier – Remove and Install

Removal Procedure
Start By:

Remove the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”.
Remove bolts (1) .

Remove rear seal carrier (2) .

Installation Procedure

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-8440     Component Cleaner        
B     169-5464     Quick Cure Primer        
C     1U-8846     Gasket Sealant        
D     9S-3263     Thread Lock Compound        

 

Clean the joint face of rear seal carrier (2) and the cylinder block with Tooling (A)

Apply Tooling (B) to the joint face of rear seal carrier (2). Allow the primer to air dry for three to five minutes.

Note: Tooling (C) is used on the joint face of rear seal carrier (2). Do not allow the sealant to get into the oil passage in the mounting face of the cylinder block.

Apply Tooling (C) to the joint face of rear seal carrier (2). Spread the sealant uniformly. Rear seal carrier (2) must be installed within ten minutes of application of the sealant.

Position rear seal carrier (2) on the dowels in the rear of the cylinder block.

Apply Tooling (D) on the threads of bolts (1). Install bolts (1) that hold rear seal carrier (2) to the cylinder block.
End By: Install the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”.

Leave a Reply

Your email address will not be published. Required fields are marked *