Removal Procedure
Start By:
A.Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”.
Note: Note the oil hole orientation in each camshaft bearing prior to removal for assembly purposes.
1.Use Tooling (A) to remove the camshaft bearings from the cylinder block.
Installation Procedure
1.Use Tooling (A) to install all of the camshaft bearings except for the front bearing. Orient oil hole (1) in each bearing so that oil hole (1) is located at the top of the bore.
2.Use Tooling (A) to install the front camshaft bearing. Align oil hole (1) in the front camshaft bearing with the oil hole in the cylinder block. Locate joint (2) in the front camshaft bearing in the proper position.
End By: Install the camshaft. Refer to Disassembly and Assembly, “Camshaft – Install”.