Use the following procedure to install the refrigerant compressor:   Install all bolts hand tight.   Tighten the top bolt (1).Tighten the bolt to the…

Note: Refer to Systems Operation/Testing and Adjusting for the correct method of inspecting the flywheel. (1) Torque for the eight locking bolts … 120 ± 20…

Illustration 1 g02112275 (6) Oil pump idler gear (7) Bolt (8) Oil pump idler gear (A) Diameter of the idler shaft … 74.000 ± 0.013…

Use compressed air in order to check the piston cooling jets for plugging. Visually inspect the piston cooling jets for damage or distortion. If damage…

Steel Piston Table 1 Specification for 212-3652 Piston and Rod Gp  Item Qty Part Specification Description – – – Install the rod and steel pistons in the…

  Note: Handle the fractured connecting rod with care. Use a soft jawed vise in order to hold the connecting rod while loosening the connecting rod…

Front Crankshaft Seal Note: The front crankshaft seal and the crankshaft seal excluder are serviced separately. (1) Install the front crankshaft seal. Ensure that the…

Table 1 Specification for 210-5590 Crankshaft Gp  Item Qty Part Specification Description A – 2W-8147 Gear Average diameter of gear after assembly is 112.48 ± 0.10 mm (4.428…

(1) Installation depth of the two cup plugs from the block face to the top edge of the plug … 1.25 ± 0.25 mm (0.049…

Left side view of engine (3) Cover (2) Install the gasket so that the bead is facing the cover. Note: Apply 1U-8846 Gasket Sealant to…