Removal Procedure Remove belt (5). Refer to Operation and Maintenance Manual, “Belts – Inspect/Replace”. Remove bolts (3) and the washers from pulley (2) and…
Author: sam
Removal Procedure Start By: Remove the electric starting motor. Refer to Disassembly and Assembly, “Electric Starter Motor – Remove and Install”. Remove bolt (1) .…
Removal Procedure Start By: Remove the crankshaft rear seal. Refer to Disassembly and Assembly, “Crankshaft Rear Seal – Remove”. Remove the electric starting motor. Refer…
Removal Procedure Start By: Remove the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”. Remove bolts (1) . Remove…
Installation Procedure Note: Replacement rear seals are supplied with a wear sleeve. This wear sleeve must be installed with the rear seal. New engines from the…
Removal Procedure Start By: Remove the flywheel. Refer to Disassembly and Assembly, “Flywheel – Remove and Install”. Use Tooling (A) to drill three evenly spaced…
Removal Procedure Attach Tooling (A) and a suitable lifting device to flywheel (1). The weight of flywheel (1) is approximately 33 kg (72 lb). …
Removal Procedure Start By: Remove the water temperature regulator housing. Refer to Disassembly and Assembly, “Water Temperature Regulator Housing – Remove and Install”. Remove bolts…
Removal Procedure Drain the coolant from the coolant system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, “Cooling System…
Installation Procedure Position the gasket and water pump (1) on the engine block. Install bolts (4) . Position elbow assembly (6) . Install bolts…