C7 Industrial Engines Disassembly and Assembly – Crankshaft Rear Seal Carrier – Remove and Install

1. Clean the joint face of rear seal carrier (2) and the cylinder block with Tooling (A) .

2. Apply Tooling (B) to the joint face of rear seal carrier (2). Allow the primer to air dry for three to five minutes.

Note: Tooling (C) is used on the joint face of rear seal carrier (2). Do not allow the sealant to get into the oil passage in the mounting face of the cylinder block.

3. Apply Tooling (C) to the joint face of rear seal carrier (2). Spread the sealant uniformly. Rear seal carrier (2) must be installed within ten minutes of application of the sealant.

4. Position rear seal carrier (2) on the dowels in the rear of the cylinder block.

5. Apply Tooling (D) on the threads of bolts (1). Install bolts (1) that hold rear seal carrier (2) to the cylinder block.

End By: Install the flywheel housing. Refer to Disassembly and Assembly, “Flywheel Housing – Remove and Install”.