Removal Procedure
Start By:
Remove the water temperature regulator housing. Refer to Disassembly and Assembly, “Water Temperature Regulator Housing – Remove and Install”.
- Remove bolts (1) and the washers from outlet pipe (2) .
- Remove outlet pipe (2) and gasket (3) .
- Remove water temperature regulators (4) from water temperature regulator housing (5) .
Installation Procedure
- Clean the mating surfaces of the water temperature regulator housings.
- Position water temperature regulators (4) into water temperature regulator housing (5) .
- Install a new gasket (3) and outlet pipe (2) .
- Install bolts (1) and the washers. Tightened bolts (1) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).
End By: Install the water temperature regulator housing. Refer to Disassembly and Assembly, “Water Temperature Regulator Housing – Remove and Install”.