(1) Torque for nut that holds the drive pulley … 68 N·m (50 lb ft) NOTE: Tighten nut more to get alignment of hole for…

Remove & Install Turbocharger Fluid Spillage Containment Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and…

S4D (1) Endplay for shaft (new) … 0.114 ± 0.038 mm (.0045 ± .0015 in) Maximum permissible endplay (worn) … 0.20 mm (.008 in) (2)…

Remove Shutoff Housing, Check Valve & Bypass Valve Fluid Spillage Containment Care must be taken to ensure that fluids are contained during performance of inspection,…

Remove Shutoff Housing NOTICE Before any service work is done on the fuel system, the outer surface of the injection pump housing must be clean.…

Disassemble Turbocharger start by: a) remove turbocharger 1. Make a mark on compressor housing (1), cartridge assembly (3) and the turbine housing (4) for correct…

Remove Turbocharger 1. Loosen hose clamps (1) on the inlet manifold. 2. Loosen clamps (2) and slide them back on tubes (3). 3. Remove two…

Disassemble Turbocharger (Schwitzer 4TF555) start by: a) remove turbocharger 1. Make a mark on compressor housing (1), cartridge assembly (3) and turbine housing for correct…

Disassemble Turbocharger (AiResearch TM6140) start by: a) remove turbocharger NOTE: Make a mark on housings and cartridge for location at assembly. 1. Loosen clamp assembly…

Remove Turbocharger 1. Loosen two clamps (1) and (3) and disconnect hoses (2) from the inlet manifold. 2. Loosen clamp (5). 3. Remove three bolts…