Remove & Install Flywheel Housing Start By: a. remove electric starting motor b. remove crankshaft rear seal and wear sleeve 1. See the topic “Flywheel…

Remove Flywheel 1. Remove eight of the ten bolts (1) holding flywheel (2) to the crankshaft. NOTE: Leave two of the bolts installed to hold…

Remove Flywheel Housing start by: a) remove starter b) remove flywheel 1. Loosen the bolts that hold the oil pan to the cylinder block. Remove…

Remove Flywheel 1. Fasten tool (A) and a hoist to flywheel (2). 2. Remove bolts (1) that hold the flywheel. Remove the flywheel. The weight…

(1) Maximum face runout of flexplate measured at bolt circle diameter … 0.76 mm (.030 in) (2) Bore runout of spacer TIR. (Total indicator reading)…

Typical Illustration (1) Flywheel shoulder. (2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of…

7C6032 Flywheel Housing NOTE: Be sure the contact surfaces of the flywheel housing and the cylinder block are clean and free of any foreign material.…

(1) Flywheel shoulder. (2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of flywheel. NOTE:…

(1) Maximum face runout of flexplate measured at bolt circle diameter … .030 in.(0.76 mm) (2) Bore runout of spacer T.I.R. (Total indicator reading) AT540…

Remove Water Pump Fluid Spillage Containment Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair…