3116 and 3126 Truck Engines Crankshaft Wear Sleeve (Rear) – Remove – If Equipped

Removal Procedure
Start By:

A.Remove the crankshaft rear seal. Refer to Disassembly and Assembly, “Crankshaft Rear Seal – Remove”.

Note: Wear sleeves are not installed at the factory. The wear sleeve is included with the replacement rear seal.

1.Install Tooling (A) in the bore of the crankshaft rear sleeve.

2.Install Tooling (B) between Tooling (A) and the crankshaft wear sleeve. Turn Tooling (B) until the edge of Tooling (B) makes a crease in the crankshaft wear sleeve. Make a crease in the crankshaft wear sleeve at two other locations around the crankshaft wear sleeve until the crankshaft wear sleeve is loose.

3.Remove Tooling (B), Tooling (A), and the crankshaft wear sleeve from the end of the crankshaft.

Leave a Reply

Your email address will not be published. Required fields are marked *