Removal Procedure Start By: A.Remove the unit injector. Refer to Disassembly and Assembly, “Unit Injector – Remove”. 1.Use Tooling (A) to remove unit injector sleeve…
Author: sam
(1) Large bolts (M20) (2) Small bolts (M10) Instructions for installing bolts (1) and (2): Put engine oil on the threads of the bolts and…
NOTE: Intake and exhaust valve stems are to be coated with engine oil prior to installation in the cylinder head. NOTE: Intake and exhaust valve…
Installation Procedure Table 1 Required Tools Tool Part Number Part Description Qty A …
Removal Procedure Start By: A.Remove the engine oil pump. Refer to Disassembly and Assembly, “Engine Oil Pump – Remove”. 1.Remove bolts (1). Remove crankshaft main…
Removal Procedure Start By: A.Remove the engine oil pan. Refer to Disassembly and Assembly, “Engine Oil Pan – Remove and Install”. 1.Remove bolt (2) and…
Connecting Rod Bearing Journals Clearance between bearing and journal (new) … 0.053 ± 0.155 mm (0.0021 ± 0.0061 in) Main Bearing Journals Clearance between bearing…
(1) Cylinder Block. (2) Gasket. (3) Bolt (location marked “Z”). Length of bolt … 30.0 mm (1.18 in) (4) Bolt (location marked “Y”). Length of…
Check piston cooling jets by inserting a 1.3 mm (0.05 in) diameter drill rod into jet. Rods must pass through a 5.0 mm (0.20 in)…
(1) Depth that cup plugs are installed (measured from block face to top edge of plug) … 1.25 ± 0.25 mm (0.049 ± 0.010 in)…