C-10, C-12, C-15 and C-16 Industrial Engines – E095 Fuel Filter Restriction Warning

Conditions Which Generate This Code:




Illustration 1	g01072866
Map for plugged fuel filter (low fuel pressure)

Table 1
Trip Level	Set Point (sec)	Reset Level	Reset Time
Refer to illustration 1 for additional information.	10 sec	10 kPa (1 psi)	4 sec

System Response:

The warning lamp will turn ON while the “Warning” is active.

The Electronic Control Module (ECM) will generate a EID 095 event code on the CAT data link. The event code will be displayed on a diagnostic screen of the Caterpillar Electronic Technician (ET).

The ECM will generate a SPN 094-FMI 00 event code on the J1939 data link. The event code may be displayed on a receiving device for the J1939 data link.

The ECM will generate a 63 flash code that will be displayed on the diagnostic lamp.

This event code indicates a restriction in the fuel filter. This does not represent a problem with the ECM.

Test Step 1.

Replace the plugged fuel filter.

Results:

OK – STOP