When the solenoid is installed, make an adjustment of the pinion clearance. The adjustment should be made with the starting motor removed. Illustration 1 g01364202…
Tag: C15
Type 1 When the solenoid is installed, make an adjustment of the pinion clearance. The adjustment can be made with the starting motor removed. Illustration…
Most of the tests of the electrical system can be done on the engine. The wiring insulation must be in good condition. The wire and…
The condition of charge in the battery at each regular inspection will show if the charging system is operating correctly. An adjustment is necessary when…
Most of the tests of the electrical system can be done on the engine. The wiring insulation must be in good condition. The wire and…
Rubber Vibration Damper (If Equipped) Illustration 1 g01124289 Vibration damper and pulley (1) Adapter (2) Rubber (3) Damper assembly (4) Bolt (5) Crankshaft pulley The…
Table 1 Tools Needed Part Number Part Name Quantity 8T-5096 Dial Indicator Gp …
Face Runout (Axial Eccentricity) of the Flywheel Table 1 Tools Needed Part Number Part Name Quantity 8T-5096…
Note: The following procedure does not require the use of an H bar to hold the liners while the liner projection measurements are taken. The…
Table 1 Required Tools Part Number Part Name Quantity 1P-3537 Dial Bore Gauge Group …