Cylinder And Valve Location (A) Exhaust valve. (B) Inlet valve. Bore … 110 mm (4.3 inch) Stroke … 127 mm (5.0 inch) Displacement … 7.25…

(1) Nut Tighten the nut to the following torque. … 8 ± 1 N·m (70 ± 9 lb in) Note: Do not switch the positive wire…

Table 1 Specification for the 161-1705 Engine Oil Pressure Sensor  Item Qty Part Specification Description 1 – – Torque the pressure sensor to 10 ± 2 N·m…

(1) Final installation torque for the liquid level sensor group … 22 ± 3 N·m (16 ± 2 lb ft) Operating temperature … -40 to…

Table 1 Specification for 130-9811 Temperature Sensor Gp , 274-7396 Temperature Sensor Gp , 197-8392 Temperature Sensor Gp, and 256-6453 Temperature Sensor  Item Qty Part Specification Description 1 1 – Torque to 20…

While the engine is stopped, install the magnetic pickup. Once the magnetic pickup is in contact with the flywheel ring gear, turn the magnetic pickup…

S/N – JRA1-UP S/N – JTF1-UP When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ……

Use the following procedure to install the refrigerant compressor:   Install all bolts hand tight.   Tighten the top bolt (1).Tighten the bolt to the…

Note: Refer to Systems Operation/Testing and Adjusting for the correct method of inspecting the flywheel. (1) Torque for the eight locking bolts … 120 ± 20…

Illustration 1 g02112275 (6) Oil pump idler gear (7) Bolt (8) Oil pump idler gear (A) Diameter of the idler shaft … 74.000 ± 0.013…