Posted on

C7 Industrial Engines Disassembly and Assembly – Housing (Front) – Remove

Removal Procedure

Start By:

Remove the speed/timing sensor. Refer to Disassembly and Assembly, “Speed/Timing Sensor – Remove and Install”.
Remove the unit injector hydraulic pump. Refer to Disassembly and Assembly, “Unit Injector Hydraulic Pump – Remove”.
Remove the auxiliary water pump. Refer to Disassembly and Assembly, “Auxiliary Water Pump – Remove”.
Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”.
Remove the crankshaft front seal. Refer to Disassembly and Assembly, “Crankshaft Front Seal – Remove”.

  1. Remove bolts (1) that fasten front housing (3) to the cylinder block.

 

  1. Remove bolts (2) that fasten the engine oil pan to the front housing.

 

  1. Remove front housing (3) from the cylinder block.Note: If necessary, hit the front housing with a soft faced hammer in order to separate the front housing from the cylinder block.

 

Posted in C7

Leave a Reply

Your email address will not be published. Required fields are marked *