Assembly Procedure
1.Position compressor housing (3) on cartridge assembly (2) and align the marks on the components.
2.Position turbine housing (1) on cartridge assembly (2) and align the marks on the components.
3.Install waste gate (5) .
4.Connect hose (4) to compressor housing (3) .
Disassembly Procedure
1.Place alignment marks on the two housings and the cartridge assembly for the correct alignment during assembly.
2.Disconnect hose (4) from compressor housing (3) .
3.Remove waste gate (5) from turbine housing (1).
4.Remove turbine housing (1) .
5.Remove compressor housing (3) from cartridge assembly (2) .
That’s very easy when you have the engine out the truck, but don’t when you have the engine block behind and many other things in front