Installation Procedure Illustration 1 g00644655 Use Tooling (A) in order to install the injection actuation pressure control valve on the unit injector hydraulic pump. Tighten…
Category: 3126
Assembly Procedure Clean the injection actuation pressure control valve and the components for the injection actuation pressure control valve. Illustration 1 g01011197 (1) O-ring seal…
Disassembly Procedure Start By: Remove the injection actuation pressure control valve. Refer to Disassembly and Assembly, “Injection Actuation Pressure Control Valve – Remove”. Illustration 1…
Removal Procedure Illustration 1 g00644654 Disconnect harness assembly (2) from injection actuation pressure control valve (1) . Remove nut (3), the spacer, and the solenoid…
(1) Fuel pump outlet. Final installation into pump, tighten to a torque of … 35 ± 3 N·m (26 ± 2 lb ft) (2) Fuel…
To replace cat 3126 fuel pump you need to follow this procedures: Removal Procedure Illustration 1 g00998298 Remove tube assembly (3) and tube assembly (2)…
Removal Procedure Illustration 1 g00998298 Remove tube assembly (3) and tube assembly (2) from fuel transfer pump (1). Plug and cap all openings. This helps…
Installation Procedure Use Tooling (B) to clean the sleeve of the unit injector. Illustration 1 g01233010 Install new O-ring seal (3) on unit injector (2)…
Removal Procedure Start By: Remove the rocker arms and the pushrods. Refer to Disassembly and Assembly, “Rocker Shaft and Pushrod – Remove”. Illustration 1 g00644454…
(1) Injection actuation pressure control valve. Final installation, tighten to a torque of … 50 ± 5 N·m (37 ± 4 lb ft) (2) Spacer.…