Valves for engines that operate in an overheated system will typically have a narrow band of oil coking near the bottom area of the valve…
Category: 3126
Multiple cylinders displayed outlines of the piston crown and the piston crater on the valve heads. This intermittent contact indicated a valve to a piston…
Valves may not display oil degradation, adhesive wear, or fretting if valve lash was too tight. Also if valve lash was too tight valve heads…
Fretting indicates repeated movement in a tight joint. Movement should not occur in the retaining area of the valve. Typically fretting is a result of…
Installation Procedure Note: Ensure that the mounting surfaces for the engine oil pump are thoroughly clean. Illustration 1 g01029320 Install the O-ring seal. Position engine…
Assembly Procedure Note: For information on the reusability of the engine oil pump, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8167, “Reconditioning Procedures…
Disassembly Procedure Start By: Remove the engine oil pump. Refer to Disassembly and Assembly, “Engine Oil Pump – Remove”. Note: For information on the reusability…
Removal Procedure Start By: Remove the engine oil pan. Refer to Disassembly and Assembly, “Engine Oil Pan – Remove and Install”. Note: For information on…
All steps of this procedure must be followed for the pressure findings to be usable. 1. Be sure that the engine is filled to the…
Section View Through Pump Gears (Typical Example) Section View Through Bypass Valve (1) Distance between outside face of gear and joint face of body ……