|
|
|
|
|
|
| Illustration 1 | g00859782 |
(1) Valve rocker arm assembly
(2) Valve lash
- Inlet valves … 0.38 ± 0.08 mm (0.015 ± 0.003 inch)
- Exhaust valves … 0.76 ± 0.08 mm (0.030 ± 0.003 inch)
Note: After the valve lash is set, tighten the adjusting screw locknut to a torque of 30 ± 7 N·m (22 ± 5 lb ft). Then recheck the valve lash.
(3) Rocker arm shaft
- Diameter of a new rocker arm shaft … 40.000 ± 0.010 mm (1.5748 ± 0.0004 inch)
- Diameter of a new rocker arm … 40.065 ± 0.015 mm (1.5774 ± 0.0006 inch)
- Bearing clearance between rocker arm and shaft … 0.040 to 0.090 mm (0.0016 to 0.0035 inch)
(4) Valve bridge assembly
(5) Camshaft
(6) Tighten bolts to 109 ± 15 N·m (80 ± 11 lb ft).