|
|
|
|
|
|
| Illustration 1 | g01527219 |
|
|
| NOTICE |
|---|
|
Before operation, the pump must be lubricated with clean engine oil and the pump must turn freely by hand or damage to parts can be the result. |
|
|
(A) Diameter of the pump drive shaft … 22.217 ± 0.005 mm (0.8747 ± 0.0002 inch)
Bore diameter in cover for shaft … 22.258 ± 0.008 mm (0.8763 ± 0.0003 inch)
(B) Length of the gear … 79.375 ± 0.025 mm (3.1250 ± 0.0010 inch)
Depth of bore for the gear … 79.502 ± 0.020 mm (3.1300 ± 0.0008 inch)
(1) 2S-2760 Spring
- Length under test force … 117.14 mm (4.612 inch)
- Test force … 499 ± 24 N (112.2 ± 5.4 lb)
- Free length after test … 152.91 mm (6.020 inch)
- Outside diameter … 27.00 mm (1.063 inch)
|
|
|
|
|
|
| Illustration 2 | g01527220 |
|
Pump body |
|
(2) Install the bearings so the bearings are even with the outside of the pump body.
(C) Position of bearing joint from the centerline through bearing bores … 30 ± 15 degrees
|
|
|
|
|
|
| Illustration 3 | g01527170 |
(D) Protrusion of two dowels in the body … 6.4 ± 0.5 mm (0.25 ± 0.02 inch)
(F) Installation depth of the sleeve bearing … 0.3 ± 0.25 mm (0.01 ± 0.010 inch)