3116 and 3126 Truck Engines Inlet Air Heater

Section View Of Heater Assembly (Dual Tube Inlet Manifold)

(1) Heater assembly.

(2) Tighten nut to a torque of … 13 ± 1 N·m (10 ± 1 lb ft)

NOTE: When assembling inlet air heater to intake manifold and air inlet elbow, clean inlet air heater joint faces with solvent. Apply 6V1541 Quick Cure Primer to joint faces. Allow primer to dry three to five minutes minimum. Apply 1U8846 Gasket Maker to joint face and spread uniformly. Heater must be assembled and tightened within ten minutes.

Leave a Reply

Your email address will not be published. Required fields are marked *