Removal Procedure
Start By:
A.Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover – Remove and Install”.
1.Put identification marks on each rocker arm in order to identify the proper location in the engine for installation.
Illustration 1 g00995386
Illustration 2 g00999153
2.Remove bolt (1) and clip (2). Loosen nut (4) .
3.Remove bolts (5). Remove jumper tube (3) .
Illustration 3 g00999165
4.Loosen all rocker arm adjustment screws (6) in order to release the tension on the rocker shaft.
5.Remove bolts (7), support bracket (8), and rocker shaft (9) .
6.Repeat Step 1 through Step 5 in order to remove the other rocker shafts.
7.Put identification marks on each pushrod in order to identify the proper location in the engine for installation.
8.Remove the pushrods from the engine.
This “instruction did not really help in any way it was vague and skipped steps IE. How to tell if pushrods in #6 cylinder are in the lifter seat ; totally useless might as well wrote about baking a cake. ……. Idiots,!