Removal Procedure
Start By:
A.Remove the flywheel. Refer to Disassembly and Assembly, “Flywheel – Remove”.
1.Fasten Tooling (A) and a suitable lifting device to flywheel housing (1) .
2.Remove bolts (2) and bolt (3) that fastens flywheel housing (1) to the cylinder block.
3.Remove flywheel housing (1) . The weight of flywheel housing (1) is approximately 32 kg (70 lb).
Installation Procedure
Correct installation of O-ring seal (3) . Do not install the O-ring seal in location (4) .
Note: On wet flywheel housings that have rear seal carriers, ensure that the 8C-3091 O-Ring Seal is installed properly. Improper installation will result in leakage of torque converter oil between the flywheel housing and the cylinder block.
Note: Ensure that the mating surface of the flywheel housing and the mounting face of the cylinder block are thoroughly clean.
1.Apply Tooling (B) to the entire mounting face of the flywheel housing prior to installation.
2.Fasten Tooling (A) and a suitable lifting device to flywheel housing (1) . Position flywheel housing (1) on the cylinder block. The weight of flywheel housing (1) is approximately 32 kg (70 lb).
3.Install bolts (2) and bolt (3) that fastens flywheel housing (1) to the cylinder block.
4.Remove Tooling (A) and the hoist from flywheel housing (1) .
5.Check the flywheel housing runout. Refer to the Systems Operation/Testing and Adjusting, “Flywheel and Flywheel Housing”.
End By: Install the flywheel. Refer to Disassembly and Assembly, “Flywheel – Install”.
It doesn’t tell you what to torque the bolts to how many foot pounds