Refer to Illustration 1. Illustration 1 g03724196

Prior to the replacement of the ECM, ensure that replacement is absolutely necessary. The ECM is seldom the cause of a failure. Always check that…

Cat ET or Caterpillar Tool Kit is required in order to configure the PL1000T. Note: In Cat ET versions prior to 2005A, the PL1000T is…

The PL1000T is “flashed” in order to upgrade the software. Flash programming of the PL1000T must also be done if the ECM has been replaced.…

Electrical problems are often caused by failed electrical wires that have either an open circuit or a short circuit. If one part of the circuit…

Electrical problems are often caused by failed electrical wires that have either an open circuit or a short circuit. If an electrical wire or a…

ReferenceSpecial Instruction, SEHS9615, “Servicing DT Connectors”. ReferenceSpecial Instruction, REHS0148, “Listing Of Deutsch Connector Components” ReferenceSpecial Instruction, SEHS9065, “Use Of CE Connector Tools”. ReferenceService Magazine, SEPD034227…

Illustration 1 g00874988 Restoring the Residual Magnetism (1) Jumper wire Reduced residual magnetism results in charging problems during start-up. Follow the procedure below in order…

Illustration 1 g00874874 Inside of the Rear Frame (1) Insulated screw (2) Insulated screw (3) Insulated screw Insulated screws (1) and (2) fasten the field…

Illustration 1 g00720873 Brush holder (1) Brushes (2) Brush length Measure the length of brushes (1). The minimum brush length (2) is 7.6 mm (0.30…