Disassembly Procedure Start By: A.Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, “Rocker Shaft and Pushrod – Remove”. Note: For information…
Tag: 3116
Removal Procedure Start By: A.Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover – Remove and Install”. 1.Put identification marks on…
Valve Mechanism Cover – Remove and Install Removal Procedure Illustration 1 g00820158 1.Remove the bolts that hold valve mechanism cover (1) to valve mechanism cover…
Valve Cover Bolts Tightening Sequence Tighten valve cover bolts in sequence shown to a torque of … 12 ± 3 N·m (9 ± 2 lb…
(1) Bore in rocker arm for shaft (new) … 24.808 ± 0.020 mm (0.9767 ± 0.0008 in) Diameter of shaft (new) … 24.755 ± 0.010…
Installation Procedure Illustration 1 g01027781 1.Install bolts (3) and the upper half of connecting rod bearing (2). Ensure that the bearing tab engages with the…
Assembly Procedure Illustration 1 g00610428 1.Check the clearance between the ends of piston rings (5). Refer to the Specifications Manual, “Pistons and Rings” topic. Note:…
Disassembly Procedure Start By: A.Remove the pistons and the connecting rods. Refer to Disassembly and Assembly, “Pistons and Connecting Rods – Remove”. 1.Use Tooling (B)…
Removal Procedure Start By: A.Remove the cylinder head. Refer to Disassembly and Assembly, “Cylinder Head – Remove”. B.Remove the engine oil pump. Refer to Disassembly…
Two Piece Articulated Piston (1) Crown assembly. (2) Connecting rod. NOTE: Install connecting rod and piston group with rod forging part number to the rear…