1. Verify that the engine is off. Illustration 1 g03099577 (1) ARD combustion head (2) ARD Nozzle Heater Wire Illustration 2 g03099598 Measuring the current…

The condition of charge in the battery at each regular inspection will show if the charging system is operating correctly. An adjustment is necessary when…

Illustration 1 g01184533 Typical example Viscous vibration damper (1) Damper (2) Crankshaft pulley (3) Bolts Damage to the vibration damper or failure of the vibration…

Adjustment Procedure Illustration 1 g02519158 Belt tensioner (1) Adjustment bolt (2) 46 mm (1-13/16 inch) jamming locknut (jam nut) (C) 22 mm (0.87 inch) Use…

Face Runout (Axial Eccentricity) of the Flywheel Housing Illustration 1 g02170084 8T-5096 Dial Indicator If you use any other method except the method that is…

Face Runout (Axial Eccentricity) of the Flywheel Illustration 1 g02166614 Checking face runout of the flywheel (1) 7H-1645 Holding Rod (2) 7H-1945 Holding Rod (3)…

Note: The following procedure does not require the use of an H bar to hold the liners while the liner projection measurements are taken. The…

Illustration 1 g01102463 (1) Adjustment screw (2) Adjustment screw locknut (3) Intake rocker arm (4) Actuator rod Put the No. 1 piston at the top…

Note: Valve lash is measured between the rocker arm and the valve bridge. All measurements and adjustments must be made with the engine stopped and…

An engine that runs roughly can have a leak at the valves. An engine that runs roughly can also have valves that need an adjustment.…