Installation Procedure Table 1 Required Tools Tool Part Number Part Description Qty A 367-3070 Fuel Injector Installer and Removal Tooling 2 D 149-2955 Seal Protector…
Author: sam
Removal Procedure Table 1 Required Tools Tool Part Number Part Description Qty A 367-3070 Fuel Injector Installer and Removal Tooling 1 B 274-9198 Leg 2…
Illustration 2 g01445696 View A-A Note: Lubricate the bore in the cylinder head lightly with the lubricant that is being sealed. Note: Install the fuel injector group…
Illustration 1 g01411601 Note: The bolts need to be replaced when the fuel transfer pump group (5) is replaced. (1) Torque for four bolts ……
The Caterpillar Electronic Technician (ET) is used to load injector trim files into the Engine Control Module (ECM). Injector trim files are available from these…
Use this procedure for the following conditions: A suspected problem with an injector solenoid You have been directed to this procedure from Troubleshooting, “Troubleshooting…
Use this procedure to troubleshoot any suspect problems with the Injection Actuation Pressure Control Valve (IAPCV). This procedure covers the following diagnostic codes: 42-05…
Use the steps that follow to check the operation of the HEUI fuel system. Circle the appropriate answers within the “Results” section of each step.…
Before you test the ether injection system, remove the ether canister from the system. Use this procedure to troubleshoot any suspect problems with the ether…
This procedure covers the following diagnostic codes: 168-00 System Voltage High 168-01 System Voltage Low 168-02 System Voltage intermittent/erratic This procedure tests whether proper…