The PL1000E Communication Electronic Control Module (ECM) requires a “Parameter Configuration List” (PCL) file in order to execute parameter translations. The PCL file contains the…
Author: sam
Modbus Parameter Translation and ECM Configuration Quick Start Guide The checklist that is in this section provides information for implementing and for configuring Modbus parameter…
Refer to the wiring schematic that is in the “System Schematic” section of this document. The PL1000E Communications ECM will require a custom wire harness…
Illustration 1 g01705933 PL1000E Communication ECM Illustration 2 g01720098 Locations of the ECM connector pins. Rear view of connector.
PL1000E configured as a Modbus Slave Cat DataLink (CDL) and/or J1939 to Modbus Parameter Translation CDL parameters are given register assignments for accessibility through the…
The PL1000E Communication Module is an “Electronic Control Module” (ECM). The PL1000E Communication Module provides the processing power, memory, and software in order to integrate…
Cat ET version 2004B (or later) or Caterpillar Communication Tool Kit version 2005A (or later) is used to connect, configure and monitor the PL1000T. Information…
Refer to the wiring schematic that is in the “System Schematic” section of this document. The PL1000E Communications ECM will require a custom wire harness…
Illustration 1 g01115230 The PL1000T Communications ECM Illustration 2 g01116887 ECM connector pin locations viewed from the back of the connector
J1939 Bridge The PL1000T, when configured to provide the “J1939 Bridge” functionality, will join two independent J1939 networks into a single J1939 network. Illustration 1…