The recommended Caterpillar service tools listed in Table 1 are required in order to enable a service technician to perform the procedures. Table 1 Required…
Author: sam
Refer to the appropriate system or the schematics of the engine harness if a troubleshooting procedure instructs the user to “Analyze and Repair the Harnessing”.…
Problem-Intermittent Sea Water Module Interface (SWMI) Information Availability on J1939 or Cat Datalink Probable Cause With only the SWMI device connected to the PL1000T, observe…
Problem-Engine Vision Display does not properly display data from the engine control Observe the “EVIM Statistics” screen with the service tool status screens. Confirm that…
Problem-Intermittent GPS Information Availability on J1939 or Cat Datalink Probable Cause Verify that the GPS module is configured for 4800 baud rate, 8 data bits,…
Problem-Remote CAN Network receives no data from Local CAN Network Probable Cause Confirm the PL1000T Communications ECM is properly connected to system power. Confirm that…
Problem-Remote CAN Network receives no data from Local CAN Network Probable Cause Confirm the PL1000T is properly connected to system power. Confirm the key switch…
Caterpillar Electronic Technician (Cat ET) Caterpillar Electronic Technician (Cat ET) is a software program that can be used on an IBM compatible personal computer. Cat…
The location of the service tool connector will vary between applications. CAT ET can be connected to the system as follows: By using the 7X-1700…
The Caterpillar service tools that are listed in Table 1 are required in order to enable a service technician to perform the procedures. Table 1…