Idler Pulley Assembly (1) Distance from back of plate assembly (3) to middle of pulley (4) … 26.0 ± 0.3 mm (1.02 ± 0.012 in)…
Author: sam
Shown With Impeller Cover Removed (1) Clearance between impeller and housing … 0.75 ± 0.25 mm (0.030 ± 0.010 in) (2) Seal. (3) Working height…
Removal Procedure 1.Drain the coolant from the cooling system into a suitable container for storage or disposal. Illustration 1 g00998920 2.Remove bolts (2) and elbow…
Removal Procedure 1.Drain the coolant from the cooling system into a suitable container for storage or disposal. Illustration 1 g00998971 2.Remove bolts (2) from water…
Removal Procedure Illustration 1 g00629979 Illustration 2 g00629985 1.Remove plug (1) and the O-ring seal from the engine oil cooler. 2.Remove valve spring (2) and…
Full open temperature … 93°C (199°F) (1) Air vent valve (2) Closed dimension … 29.5 ± 0.5 mm (1.16 ± 0.02 in) (3) Minimum stroke…
Installation Procedure Illustration 1 g01026362 1.Install O-ring seals (2) in the cylinder block. 2.Put the gasket and engine oil cooler (1) in the cylinder block.…
Removal Procedure Start By: A.Remove the engine oil filter base. Refer to Disassembly and Assembly, “Engine Oil Filter Base – Remove”. Illustration 1 g01026362 1.Remove…
Typical Example (1) Oil cooler bypass valve to open at … 125 ± 30 kPa (18 ± 4.5 psi) 9L9188 Spring for oil cooler bypass…
Removal Procedure Start By: A.Remove the fuel filter base. Refer to Disassembly and Assembly, “Fuel Filter Base – Remove and Install”. B.Remove the rocker arms…