llustration 1 g00709948 Starting motor components (1) Rear frame assembly (2) Solenoid assembly (3) Plunger assembly (4) Shift lever housing (5) Shift lever assembly (6)…
Author: sam
Illustration 1 g00712156 50-MT series starting motor The 50-MT series starting motor may be ordered in the following versions: 24 volt, 32 volt and 64…
General Information Illustration 1 g00719183 Rest Position (1) Return Spring (2) Solenoid (3) Pull-In Winding (4) Start (S) Terminal (5) Hold-In Winding (6) Battery (Bat)…
Illustration 1 g00718697 (1) Rear Housing (2) Solenoid (3) Plunger (4) Shift Lever Housing (5) Shift Lever (6) Drive Housing (7) Pinion Drive (8) Brushes…
Illustration 1 g00717738 42-MT Starting Motor The heavy-duty starting motors are offered in 24Vand 12V versions. The 37-MT and 41-MT are similar in operation and…
The following procedure is used in order to perform the no-load test after the starting motor has been repaired. The test should also be performed…
Installation Procedure Illustration 1 g00614182 1.Clean surface (7) . 2.Inspect the condition of the O-ring seals. Replace the seals, if necessary. Illustration 2 g00614173 3.Install…
Assembly Procedure Illustration 1 g00614283 1.Install the shaft and the bearing into pulley (3) with a press. Install the shaft until the shaft is flush…
Disassembly Procedure Start By: A.Remove the water pump. Refer to Disassembly and Assembly, “Water Pump – Remove”. Illustration 1 g01026865 1.Remove rear cover (1) .…
Removal Procedure Start By: A.Remove the belt tensioner. Refer to Disassembly and Assembly, “Belt Tensioner – Remove and Install”. 1.Drain the coolant from the cooling…