Sleeve Metering Fuel System (SMFS) Fuel Flow Schematic (1) Fuel priming pump (closed position). (2) Fuel priming pump (open position). (3) Return line for constant…
Author: sam
Electronic Controls The engine’s electronic system consists of the Engine Control Module (ECM), the engine sensors and the vehicle interface. The ECM is the computer.…
All Marine, Industrial, Generator Set Engines Except 3600 Family Of Engines Reference: Engine News; November, 1985; Page 5, “Engine Shuts Down Immediately After Start-up”. Engine…
All Products With Direct Electric Starting Reference: Service Magazine; May 28, 1990; Page 4; “Jump Starting Procedures.” Service Magazine; May 4, 1987; Page 10; “Alternator/Generator…
Bolt and torque sequence of 3306 cylinder head final assembly
nspect head bolts for reusability. Replace the head bolts that have surface damage (pitting or erosion) on the shank that cannot be polished smooth. The…
NOTE: This procedure alleviates the need for the “H” bar to hold down liners during projection measurements. Illustration 1. Liner projection components 1. Bolt. 2.…
Counterbore only the block liner seats that exhibit measurable erosion of 0.025 mm (0.001 in) or greater. Generally, liner seat erosion resulting from a head…
Cylinder block top deck cleaning. Clean the cylinder block top deck completely with wire brush or “Scotchbrite” pad. Use caution when cleaning around the liner…
Use a 6V7059 Micrometer to measure the thickness of the flange. Measure the thickness of the flange with a 6V7059 Micrometer. Use the liner again…