9S8521 Rod.9S8518 Plug.8S4627 Circuit Tester.1P2385 Protractor Tool. Four adjustments must be made: 1: linkage adjustment. 2: low speed setting. 3: high speed setting. 4: regulation,…

1P87 Adjusting Wrench. Whenever the governor is disassembled the pilot valve plunger central position adjustment should be checked and adjusted if necessary. PILOT VALVE PLUNGER…

Adjustment is made on the inside of the governor after removing the cover on which the synchronizing motor is mounted. SPEED DROOP ADJUSTMENT 1. Clamp…

Before making this adjustment the installation adjustment should be made, and if done correctly, it will never require changing unless the governor is disturbed. High…

When the governor linkage adjustments are correct, the following adjustments should be made. 1. Position the speed adjusting shaft for desired running speed and allow…

Illustrated here are three basic usages of 1P2385 Protractor Tool 1P2385 PROTRACTOR TOOL USAGE A-Angle setting indicator. B-Protractor plate edge aligned with lever. C-Vertical housing…

9S240 Rack Positioning Tool Group.8S7115 Wire.8S8159 Seals. 8S8157 Sealing Tool.1P2385 Protractor Tool. PARTS OF 9S240 RACK POSITIONING TOOL GROUP 1. 8S4627 Circuit Tester. 2. 9S8518…

SOLID STATE IGNITION SYSTEM 1. Transformer. 2. Wiring harness. 3. Spark plug cover. 4. Solid state magneto. 5. Timing bolt. The solid state ignition system…

Water Temperature Contactor Switch A water temperature sending unit is located in the water temperature regulator housing. The unit is nonadjustable. Thermal expansion of the…

Switch SW-1 contacts bypass initiating contacts so initiating relay energizes, and through its contacts, magnetic switch is energized. Magnetic switch closes and cranking action begins.…