The NRS sends hot exhaust gas from the exhaust manifold that is connected to cylinders one, two, and three through the NRS system. In order…
Author: sam
Two turbochargers are arranged in a series on some C18 applications. (A) To the aftercooler (B) From the actuator on the balance valve (C) To…
Inlet air is pulled through the air cleaner. The inlet air is then compressed and heated by the compressor wheel of turbocharger to about 150…
Illustration 1 g01914641 Air inlet and exhaust system (1) Air-to-air aftercooler (ATAAC) (2) Exhaust manifold (3) Turbocharger (4) Air Cleaner (5) Clean Emissions Module (CEM)…
Disassemble Turbocharger (Airesearch T12) start by: a) remove turbocharger 1. Install the turbocharger on tool (A). 2. Put marks on the housing for correct installation…
Remove Turbocharger (Industrial Engine) 1. Remove bolts (2) and remove exhaust elbow and support (1) as a unit. 2. Remove coupling (3) from the turbocharger…
Remove Precombustion Chambers start by: a) remove fuel injection valve 1. Remove the coolant from the cooling system. Capacity is 11 U.S. gal. (41 liter).…
Remove Fuel Injection Valves (Industrial Engine) 1. Disconnect fuel injection line (1). Put a cap on the opening. Remove nut (2). 2. Remove the fuel…
Remove Crankshaft Drive Gear start by: a) remove oil pump b) remove crankshaft front seal wear sleeve c) remove timing gears and plate 1. Pull…
Remove Vibration Damper And Pulley (Marine Engine) 1. Remove the vibration damper and pulley bolt (3) and plate (2). 2. Install the washer (1) on…