Removal Procedure
- Disconnect harness assembly (1) from atmospheric pressure sensor (2) .
- Remove atmospheric pressure sensor (2) and the O-ring seal.
Installation Procedure
Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
- Install the O-ring seal onto atmospheric pressure sensor (2) .
- Install atmospheric pressure sensor (2) and the O-ring seal. Tighten atmospheric pressure sensor (2) to a torque of 10 ± 2 N·m (88 ± 18 lb in).
- Connect harness assembly (1) to atmospheric pressure sensor (2) .
One Reply to “C7 Industrial Engines Disassembly and Assembly – Atmospheric Pressure Sensor – Remove and Install”