C7 Industrial Engines Disassembly and Assembly – Speed/Timing Sensor – Remove and Install

Removal Procedure

Start By:

Remove the air compressor. Refer to Disassembly and Assembly, “Air Compressor – Remove and Install”.

1. Disconnect harness assemblies (2) from speed/timing sensors (1) .

2. Remove bolt (3), washer (4), and bracket (5). Remove speed/timing sensors (1). Remove the O-ring seals from speed/timing sensors (1) .

Installation Procedure

Note: Check the O-ring seals for wear or for damage. If necessary, replace the O-ring seals.

1. Apply Tooling (A) to the O-ring seals prior to installation. Install speed/timing sensors (1) .

2. Position bracket (5) and install bolt (3) and washer (4). Tighten bolt (3) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).

3. Connect harness assemblies (2) onto speed/timing sensors (1) .

End By: Install the air compressor. Refer to Disassembly and Assembly, “Air Compressor – Remove and Install”.