| Illustration 1 | g00768439 |
| (1) Breather assembly
(2) Bolt (3) Hose clamp (4) Hose |
|
- Loosen hose clamp (3) and remove hose (4) from breather assembly (1) .
- Remove bolt (2) and the washer. Remove the breather assembly (1) and the seal.
- Wash the breather element in solvent that is clean and nonflammable. Allow the breather element to dry before installation.
- Install a breather element that is clean and dry. Install breather assembly (1) and the seal.
- Install bolt (2) and the washer. Refer to Specifications, SENR3130, “Torque Specifications” for the correct torque.
- Install hose (4) on breather assembly (1). Tighten hose clamp (3). Refer to Specifications, SENR3130, “Torque Specifications” for the correct torques.