(1) End play for shaft (new) … .0045 ± .0015 in.(0.114 ± 0.038 mm)
Maximum permissible end play (worn) … .008 in.(0.20 mm)
(2) Thickness of thrust bearing … .211 ± .001 in.(5.36 ± 0.03 mm)
(3) Diameter of surface on shaft (journal) for the bearing (new) … .5612 to .5615 in.(14.254 to 14.262 mm)
Bore in the bearing (new) … .5627 to .5630 in.(14.293 to 14.300 mm)
Maximum permissible clearance between bearing and shaft (worn) … .003 in.(0.08 mm)
(4) Put 5P3931 Anti-Seize Compound on threads and tighten bolt holding band clamp to … 120 lb.in.(13.6 N·m)
(5) Maximum permissible gap of oil seal ring, measured in bore of housing … .009 in.(0.23 mm)
(6) Nut for impeller (See TURBOCHARGER IMPELLER INSTALLATION).
|
|
| NOTICE |
|---|
|
Do not bend or add stress to the shaft when nut is tightened. |
|
|
(7) Bore in housing (new) … .8762 to .8767 in.(22.255 to 22.268 mm)
Outside diameter of the bearing (new) … .8718 to .8722 in.(22.144 to 22.154 mm)
Maximum permissible clearance between bearing and bore in housing (worn) … .006 in.(0.15 mm)
(8) Thickness of each thrust ring … .1005 ± .0005 in.(2.553 ± 0.013 mm)