Remove Rocker Shafts And Push Rods
start by:
a) remove the valve covers
1. Remove bolts (2) from rocker shaft (3) and remove rocker shaft. Remove push rods (1).
Install Rocker Shafts And Push Rods
1. Install push rods (2). Put rocker shaft (1) in position on the engine. Tighten the bolts to a torque of 18 ± 5 lb. ft. (24 ± 7 N·m).
2. Make adjustment until the intake valve clearance is .015 in. (0.38 mm) and the exhaust valve clearance is .025 in. (0.64 mm). Tighten nuts (3) to a torque of 24 ± 5 lb. ft. (30 ± 7 N·m).
end by:
a) install valve covers