Removal Procedure
Illustration 1 g00642608
1.Remove ether atomizer (1) from the top of the air inlet manifold.
Installation Procedure
Illustration 2 g00642608
Note: Install the ether atomizer so that the direction of the spray is parallel to the air inlet heater, If equipped. The ether atomizer has an indicator in order to show the direction of the spray.
Note: The ether atomizer has two ports that are separated by 180 degrees. The two ports must be aimed parallel to the length of the block.
1.Install ether atomizer (1). The minimum torque for the ether atomizer is 2.8 N·m (25 lb in).