Cat ET version 2004B (or later) or Caterpillar Communication Tool Kit version 2005A (or later) is used to connect, configure and monitor the PL1000T. Information…

Refer to the wiring schematic that is in the “System Schematic” section of this document. The PL1000E Communications ECM will require a custom wire harness…

Illustration 1 g01115230 The PL1000T Communications ECM Illustration 2 g01116887 ECM connector pin locations viewed from the back of the connector

J1939 Bridge The PL1000T, when configured to provide the “J1939 Bridge” functionality, will join two independent J1939 networks into a single J1939 network. Illustration 1…

PL1000T Communications Module The PL1000T Communications ECM is an “Electronic Control Module” (ECM) that is designed in order to provide the following communication features: Customer…

Illustration 1 g00901310 27-SI Alternator (1) Field Winding (2) Rotor (3) Stator (4) Regulator (5) Rectifier (6) Capacitor (7) Diode Assembly Field Winding Illustration 2…

The field winding uses DC voltage to create a magnetic field. The magnetic field magnetizes the rotor. The rotor rotates the magnetic field on the…

Illustration 1 g00901038 27-SI Alternator The alternator is an electromechanical component that converts mechanical energy into electrical energy. The alternator charges the storage battery during…

General Information Illustration 1 g00719183 Rest Position (1) Return Spring (2) Solenoid (3) Pull-In Winding (4) Start (S) Terminal (5) Hold-In Winding (6) Battery (Bat)…

Illustration 1 g00718697 (1) Rear Housing (2) Solenoid (3) Plunger (4) Shift Lever Housing (5) Shift Lever (6) Drive Housing (7) Pinion Drive (8) Brushes…