Illustration 1 g01705933 PL1000E Communication ECM Illustration 2 g01720098 Locations of the ECM connector pins. Rear view of connector.

PL1000E configured as a Modbus Slave Cat DataLink (CDL) and/or J1939 to Modbus Parameter Translation CDL parameters are given register assignments for accessibility through the…

The PL1000E Communication Module is an “Electronic Control Module” (ECM). The PL1000E Communication Module provides the processing power, memory, and software in order to integrate…

Cat ET version 2004B (or later) or Caterpillar Communication Tool Kit version 2005A (or later) is used to connect, configure and monitor the PL1000T. Information…

Refer to the wiring schematic that is in the “System Schematic” section of this document. The PL1000E Communications ECM will require a custom wire harness…

Illustration 1 g01115230 The PL1000T Communications ECM Illustration 2 g01116887 ECM connector pin locations viewed from the back of the connector

J1939 Bridge The PL1000T, when configured to provide the “J1939 Bridge” functionality, will join two independent J1939 networks into a single J1939 network. Illustration 1…

PL1000T Communications Module The PL1000T Communications ECM is an “Electronic Control Module” (ECM) that is designed in order to provide the following communication features: Customer…

Illustration 1 g00901310 27-SI Alternator (1) Field Winding (2) Rotor (3) Stator (4) Regulator (5) Rectifier (6) Capacitor (7) Diode Assembly Field Winding Illustration 2…

The field winding uses DC voltage to create a magnetic field. The magnetic field magnetizes the rotor. The rotor rotates the magnetic field on the…