Illustration 1 g00874988 Restoring the Residual Magnetism (1) Jumper wire Reduced residual magnetism results in charging problems during start-up. Follow the procedure below in order…

Illustration 1 g00874874 Inside of the Rear Frame (1) Insulated screw (2) Insulated screw (3) Insulated screw Insulated screws (1) and (2) fasten the field…

Illustration 1 g00720873 Brush holder (1) Brushes (2) Brush length Measure the length of brushes (1). The minimum brush length (2) is 7.6 mm (0.30…

Stator Winding Continuity Test Illustration 1 g00873098 Stator (1) Leads (2) Frame Remove the stator from the alternator. Connect the multimeter leads across each pair…

The regulator test determines problems in the following components: the regulator, the field winding, the rectifier and the diode assembly. The regulator test does not…

Illustration 1 g00873381 Rectifier (1) Negative diode clips (2) Grounded heat sink (3) Positive diode clips (4) Insulated heat sink For the following tests, bend…

Illustration 1 g00872663 Field Winding (1) Leads (2) Housing Field Winding Continuity Test Remove the field winding from the alternator. Connect the multimeter leads across…

Illustration 1 g00873253 Diode Assembly (1) Terminal (2) Terminals Remove the diode assembly from the alternator. Set the multimeter to the diode scale. Connect the…

Illustration 1 g00901704 Capacitor (1) Housing (2) Terminal Remove the capacitor from the alternator. Touch terminal (2) to housing (1) in order to discharge the…

37-MT Starting Motors (12 Volt Systems) Illustration 1 g00810014 Connections for pinion clearance check for 12 volt system (1) Battery (2) Starting motor (3) Solenoid…