Caterpillar Engines Troubleshooting

Cat Engines Maintenance & Repair Guides

Skip to content
Menu
  • Home
  • About Me
  • Contact Us
  • Privacy Policy

Category: C18

C18

C13, C15, and C18 Engines Troubleshooting – Crankcase Pressure Is High

Posted on October 14, 2020 by sam

The engine is equipped with an open crankcase ventilation (OCV) system. Refer to Illustration 1. The pressure sensor monitors the level of crankcase pressure. The…

C18

C13, C15, and C18 Engines Troubleshooting – Crankcase Fumes Disposal Tube Has Oil Draining

Posted on October 14, 2020 by sam

Probable Cause Illustration 1 g02211761 (1) Crankcase pressure sensor (2) Crankcase filter housing (3) Fumes disposal tube (4) Oil drain tube Illustration 2 g02013955 Left…

C18

C13, C15, and C18 Engines Troubleshooting – Cooling Fan Is Always ON

Posted on October 14, 2020 by sam

Probable Causes   Operation of the Cooling Fan  Recommended Actions Table 1 Troubleshooting Test Steps Values Results 1. Check the Operation of the Cooling Fan…

C18

C13, C15, and C18 Engines Troubleshooting – E361(1)/E361(2)/E361(3) Coolant Temperature Is High

Posted on October 14, 2020October 8, 2023 by sam

Use this procedure in order to troubleshoot high coolant temperature or use this procedure if one of the following event codes is active. Refer to…

C18

C13, C15, and C18 Engines Troubleshooting – Coolant Level Is Low

Posted on October 14, 2020 by sam

Use this procedure in order to troubleshoot low coolant level or use this procedure if one of the following codes is active. Refer to Troubleshooting,…

C18

C13, C15, and C18 Engines Troubleshooting – Coolant Contains Oil

Posted on October 14, 2020 by sam

Probable Causes Engine Oil Cooler Power Train Oil Cooler (if equipped) Water-Cooled Turbocharger Cylinder Head Gasket Block The procedures have been listed in order of…

C18

C13, C15, and C18 Engines Troubleshooting – Coolant Contains Fuel

Posted on October 14, 2020 by sam

Probable Causes Leaking injector sleeve and/or damaged seal Recommended Actions Table 1 Troubleshooting Test Steps Values Results 1. Leaking injector sleeve and/or damaged seal A.…

C18

C13, C15, and C18 Engines Troubleshooting – ARD Temperature Is Low

Posted on October 14, 2020 by sam

System Operation Description: Table 1 lists the diagnostic code that relates to low Aftertreatment Regeneration Device (ARD) temperature. Note: Refer to Troubleshooting, “Cat ET Service Features”…

C18

C13, C15, and C18 Engines Troubleshooting – ARD Loss of Combustion

Posted on October 14, 2020 by sam

System Operation Description: Table 1 lists the diagnostic code that relates to the combustion air system. Note: Some of the following codes may not be applicable…

C18

C13, C15, and C18 Engines Troubleshooting – ARD Is Disabled

Posted on October 14, 2020 by sam

Use this procedure in order to troubleshoot a failed aftertreatment regeneration or use this procedure if one of the following event codes are active. Refer…

Posts pagination

Previous Page Page 1 … Page 9 Page 10 Page 11 … Page 20 Next Page

Resources

  • About Me
  • Contact Us
  • Privacy Policy

Categories

  • 3126
  • 3126
  • 3208
  • 3306
  • 3406E
  • BX-2150
  • C15
  • C18
  • C7
  • Cat ID
  • D330
  • Delco 27SI
  • EL-740
  • Engine News
  • Programming
  • Service Magazine
  • Special Instruction
  • Troubleshooting
  • Uncategorized

Recent Posts

  • Cat C7 Injection Actuation Pressure Sensor Location
  • Programming – A/C Pressure Switch Fan-On Time
  • Programming – Minimum & Maximum Idle Shutdown Outside Temperature
  • Programming – Allow Idle Shutdown Override
  • Programming – Idle Shutdown Timer
© Copyright 2026 – Caterpillar Engines Troubleshooting
Wisteria Theme by WPFriendship ⋅ Powered by WordPress

Privacy Policy