Introduction This Special Instruction provides the necessary information on all welding procedures. Proper Cleaning for Inspection Before you inspect the area, clean the area…
Category: Special Instruction
Introduction Procedure to prevent injector Plunger Spring failure due to inadequate fuel system priming. The low-pressure fuel system must be primed after injector replacement…
Caterpillar Products: All (Except Unregulated, Tier 0, Tier 3, and Tier 4 Engines) Introduction NOTICE Diesel Particulate Filters (DPF) are not applicable…
Asphalt Paver: AP-1000D (S/N: EAD1-UP) AP-1055D (S/N: FAC1-UP; A6P1-UP) BG-2455D (S/N: BNW1-UP; BXW1-UP) BG-260D (S/N: BPW1-UP) Engine: C7 (S/N: JRA1-UP; JTF1-UP) Marine Engine: C7 MARINE…
8T5300 Timing Indicator Group (1) 8T5250 Engine Timing Indicator. (2) 5P7366 Cable Assembly. (3) 6V2197 Magnetic Transducer. (4) 5P7362 Cable. (5) 6V2199 & 6V3093 Transducer…
These instructions cover the installation of 3S6610 Cage in place of 2S1489 Cage or 2S4699 Cage in water pumps on both 4 and 6 cylinder,…
3300, 3400 Series and 6.25″ Bore Vee Engines Introduction This instruction gives the procedure for inspecting and installing water pump seal groups. Correct inspection and…
All 4.75″ (120.6) Bore Engines With 2 Valves Per Cylinder Replacement thrust plates are available for the crankshaft of both the counterbored cylinder blocks, and…
Engine: 3400 All, 3300 All, 3200 All, 3100 All, 3000 All, and D-series All All 3500 Engines All 3600 Engines All C280 Engines C-10 All…
All Sleeve Metering Fuel Injection Pump Housings (1) The 8N628 Bearing (1) can be installed as a service replacement for the rear bearing of the…