Electrical problems are often caused by failed electrical wires that have either an open circuit or a short circuit. If one part of the circuit…

Electrical problems are often caused by failed electrical wires that have either an open circuit or a short circuit. If an electrical wire or a…

ReferenceSpecial Instruction, SEHS9615, “Servicing DT Connectors”. ReferenceSpecial Instruction, REHS0148, “Listing Of Deutsch Connector Components” ReferenceSpecial Instruction, SEHS9065, “Use Of CE Connector Tools”. ReferenceService Magazine, SEPD034227…

Illustration 1 g00874988 Restoring the Residual Magnetism (1) Jumper wire Reduced residual magnetism results in charging problems during start-up. Follow the procedure below in order…

Illustration 1 g00874874 Inside of the Rear Frame (1) Insulated screw (2) Insulated screw (3) Insulated screw Insulated screws (1) and (2) fasten the field…

Illustration 1 g00720873 Brush holder (1) Brushes (2) Brush length Measure the length of brushes (1). The minimum brush length (2) is 7.6 mm (0.30…

Stator Winding Continuity Test Illustration 1 g00873098 Stator (1) Leads (2) Frame Remove the stator from the alternator. Connect the multimeter leads across each pair…

The regulator test determines problems in the following components: the regulator, the field winding, the rectifier and the diode assembly. The regulator test does not…

Illustration 1 g00873381 Rectifier (1) Negative diode clips (2) Grounded heat sink (3) Positive diode clips (4) Insulated heat sink For the following tests, bend…

Illustration 1 g00872663 Field Winding (1) Leads (2) Housing Field Winding Continuity Test Remove the field winding from the alternator. Connect the multimeter leads across…