(1) Maximum face runout of flexplate measured at bolt circle diameter … 0.76 mm (.030 in) (2) Bore runout of spacer TIR. (Total indicator reading)…
Author: sam
Typical Illustration (1) Flywheel shoulder. (2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of…
7C6032 Flywheel Housing NOTE: Be sure the contact surfaces of the flywheel housing and the cylinder block are clean and free of any foreign material.…
(1) Flywheel shoulder. (2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of flywheel. NOTE:…
3208 INDUSTRIAL ENGINE ATTACHMENTS – Mounting Group For AT540, MT643, and MT653 Allison Transmission
(1) Maximum face runout of flexplate measured at bolt circle diameter … .030 in.(0.76 mm) (2) Bore runout of spacer T.I.R. (Total indicator reading) AT540…
Remove Water Pump Fluid Spillage Containment Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair…
Remove & Install Governor & Fuel Pump Drive Start By: a. remove timing gear cover & oil pump 1. Remove the plug from the fuel…
Remove Fan Drive 1. Remove the fan from the fan drive. 2. Release the tension on the fan belts by loosening nuts (1) on the…
Install the damper assembly on the crankshaft until the hub of the damper assembly comes in contact with the gear on the crankshaft. DO NOT…
Install the damper assembly on the crankshaft until the hub of the damper assembly comes in contact with the gear on the crankshaft. DO NOT…