Removal Procedure Start By: A.Remove the cylinder head. Refer to Disassembly and Assembly, “Cylinder Head – Remove”. B.Remove the engine oil pump. Refer to Disassembly…
Author: sam
Two Piece Articulated Piston (1) Crown assembly. (2) Connecting rod. NOTE: Install connecting rod and piston group with rod forging part number to the rear…
(1) Bore in bearing for piston pin (new) … 40.028 ± 0.008 mm (1.5759 ± 0.0003 in) To install bearing, rod may be heated at…
Removal Procedure 1.Drain the engine oil into a suitable container for storage or disposal. Typical example Note: Do not pry or gouge the sealing surface…
Removal Procedure Start By: A.Remove the flywheel. Refer to Disassembly and Assembly, “Flywheel – Remove”. 1.Fasten Tooling (A) and a suitable lifting device to flywheel…
Typical Example NOTE: Write the dial indicator measurements with their positive (+) and negative (-) notation (signs). This notation is necessary for making the calculations…
Face Runout (Axial Eccentricity) Of The Flywheel Housing: 8T5096 Dial Indicator Group Installed (Typical Example) 1. Fasten a dial indicator to the crankshaft flange so…
Typical Example See the topics, Flywheel Housing Runout and Flywheel Housing Bore, for the correct methods of flywheel housing inspection. NOTE: Apply 1U8846 Gasket Maker…
Removal Procedure Start By: A.Remove the front housing. Refer to Disassembly and Assembly, “Housing (Front) – Remove”. 1.Rotate the crankshaft until the number one piston…
Installation Procedure Note: For information on reusability of the camshaft idler gear, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8045, “Timing Gears for…