(1) Magnetic switch assembly. (2) Torque for terminal nuts … 4 N·m (35 lb in) (3) Air inlet elbow. (4) Nut. Tighten nut to ……
Author: sam
Section View Of Heater Assembly (Dual Tube Inlet Manifold) (1) Heater assembly. (2) Tighten nut to a torque of … 13 ± 1 N·m (10…
Removal Procedure Illustration 1 g00693487 1.Loosen screw (3) until harness assembly (1) can be disconnected. Disconnect harness assembly (1) from electronic control module (2) .…
Top View Left Side View (1) Coolant temperature sensor. (2) Inlet manifold pressure (boost) sensor. Tighten to a torque of … 10 ± 2 N·m…
Removal Procedure Illustration 1 g00609523 Typical Example Note: Release the tension on the belt at the belt tightener, if the engine is not equipped with…
Voltage rating … 12 V Polarity … negative ground Voltage range at 25°C (77°F) … 14.0 ± .3 V
Voltage rating … 12 V Polarity … negative ground Rotation … either direction Turn on speed (maximum) … 2000 rpm Output voltage at [25°C (77°F)]…
System Operation Description: The possible causes of this failure are listed below: •The solenoid return spring is weak. •The solenoid return spring is broken. •The…
System Operation Description: The possible causes of this failure are listed below: •The ignition switch is faulty. •The solenoid of the starting motor is faulty.…
System Operation Description: The possible causes of this failure are listed below: •The battery is discharged or the battery is faulty. •The cables to the…